Uploaded November 2018 | Updated November 2026, 4 days ago
Our standalone harnesses aren't just for the MK1 Chassis. You can install VW motors in virtually any car. Honda, Toyota, Lawn mowers, Ferrari, Rabbit ,MK2 Scirocco AND MORE! Fabrication of course is always required for the engine mounts but the wiring is simple.
Harness's come bare unless the option of wrapping is chosen. We wrap our harnesses in cloth friction free tape. All our plug and play standalone engine harnesses come standard with battery leads, relay holders, and self terminated relays; this means no butt connectors and solder joints. Relays are extended so they can be positioned next to the Main ECU connector so it stays dry. OBD2 data link connector (when applicable) and Always OEM Bosch hardware only!
The Eurowise difference!
The same good stuff from Germany. We also offer them to be wrapped in Raychem motorsport heat shrink. This is the expensive stuff that you see in F1 cars.
Contact us if you are looking for a full blown Mil-spec harness. We offer these services too!
These are some of harnesses we make, if you don't see it listed just send us an email! info@eurowise.com
-VR6
-R32
-3.6 VR6
-ABA
-1.8t
-TDI
-5 Cylinder
- Using the factory twist lock connector the harness plugs into and the rest is cake walk!
- Harness will work on any make or model as long as used on OBD1 / OBD2 VR6 motors
- OEM friction tape wrapped (optional)
- OEM connectors
- OBD 2 Diagnostic Connector Wired in (OBD 2 only)
We stock most harnesses but if you have your donor motor harness than that saves you money!
Ship us your good un-cut harness.
Order online : Shop.eurowise.com
Email: info@eurowise.com
Our standalone harnesses aren't just for the MK1 Chassis. You can install VW motors in virtually any car. Honda, Toyota, Lawn mowers, Ferrari, Rabbit ,MK2 Scirocco AND MORE! Fabrication of course is always required for the engine mounts but the wiring is simple.
Harness's come bare unless the option of wrapping is chosen. We wrap our harnesses in cloth friction free tape. All our plug and play standalone engine harnesses come standard with battery leads, relay holders, and self terminated relays; this means no butt connectors and solder joints. Relays are extended so they can be positioned next to the Main ECU connector so it stays dry. OBD2 data link connector (when applicable) and Always OEM Bosch hardware only!
The Eurowise difference!
The same good stuff from Germany. We also offer them to be wrapped in Raychem motorsport heat shrink. This is the expensive stuff that you see in F1 cars.
Contact us if you are looking for a full blown Mil-spec harness. We offer these services too!
These are some of harnesses we make, if you don't see it listed just send us an email! info@eurowise.com
-VR6
-R32
-3.6 VR6
-ABA
-1.8t
-TDI
-5 Cylinder
- Using the factory twist lock connector the harness plugs into and the rest is cake walk!
- Harness will work on any make or model as long as used on OBD1 / OBD2 VR6 motors
- OEM friction tape wrapped (optional)
- OEM connectors
- OBD 2 Diagnostic Connector Wired in (OBD 2 only)
We stock most harnesses but if you have your donor motor harness than that saves you money!
Ship us your good un-cut harness.
Order online : Shop.eurowise.com
Email: info@eurowise.com










