Uploaded February 2020 | Updated September 2026, 2 hours ago

---

This is my first ever cutting board that I have made using walnut and total boat epoxy for the engraving part. So.... since this is my first cutting board I wasn't 100 percent sure what I was doing and you can see that by the cupping problem I had. I used an interesting trick to add steam to the boat to get it back flat and WOW it actually worked.

oxintheshop.com
facebook.com/oxintheshop
instagram.com/oxintheshop

5% off TotalBoat purchase
totalboat.refr.cc/drewoxford

Tools Used:
Delta Table saw(can't find same 1 this 1 is more $) amzn.to/2BQkZhM
Dewalt Miter Saw: amzn.to/385xe81
Grizzly 20 inch planer: amzn.to/3a9iVAK
Bessey Clamps: amzn.to/2uCkqIU
Tietbond 3 glue: amzn.to/392FVl2
Festool Sander: amzn.to/2uB7CT4
V bit: amzn.to/3c9sqSl
Cutting board Oil: amzn.to/2HZfDUI

Disclaimer: This video contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission. Thank you for your support

music from epidmenicsound.com