Uploaded June 2023 | Updated September 2026, 54 minutes ago

---

In this video, I fix the loop stability issue with the power supply I made for the EGO battery-powered soldering station. Part one can be found here youtu.be/d47xh3FgALA. If you want to make the board or check out the design, it is here: oshwlab.com/garnerm91/56v-to-24v-5amp This project is sponsored by JLCPCB, $2 For Your PCB+PCBA, Register to Get $54 Coupons: jlcpcb.com/IYB

Supplies used in this video found on Amazon:
T12 Station: amzn.to/3WNQodE
Flux: amzn.to/3N9mM6n
Solder: amzn.to/45WVloS
Oscilloscope: amzn.to/3MQzzKr