Uploaded January 2019 | Updated September 2026, 1 hour ago
E&C entry level complete gearbox. Even though standard parts compression is excellent straight out of the box. Upon inspection the gearbox was shimmed and greased although I advise running the gearbox for a short while and then re-shim and re-grease. FPS on 0.2g averaged around 410. Uses a standard trigger switch block, once fitted into a lower receiver the rear cable extends around 9".
Features
- Steel spring guide with bearing
- Linear spring 410 fps
- T9 screws
- 15 tooth full steel racked piston
- 3/4 brass cylinder
- Plastic nozzle (no o-ring)
- Plastic cylinder with flat pad bottom
- Plastic piston
- Standard machined 18:1 gears (10 point bevel)
- Tamiya connector
- 8mm bearings
E&C entry level complete gearbox. Even though standard parts compression is excellent straight out of the box. Upon inspection the gearbox was shimmed and greased although I advise running the gearbox for a short while and then re-shim and re-grease. FPS on 0.2g averaged around 410. Uses a standard trigger switch block, once fitted into a lower receiver the rear cable extends around 9".
Features
- Steel spring guide with bearing
- Linear spring 410 fps
- T9 screws
- 15 tooth full steel racked piston
- 3/4 brass cylinder
- Plastic nozzle (no o-ring)
- Plastic cylinder with flat pad bottom
- Plastic piston
- Standard machined 18:1 gears (10 point bevel)
- Tamiya connector
- 8mm bearings
