Uploaded November 2013 | Updated November 2026, 3 hours ago
Please excuse the mess in the background.
Two carriages used as X and Y axis, a servo lifts the pen. The pen carriage is 3D printed, the steel rods come from a third DVD carriage.
The whole thing is driven by an Arduino Duemilanove with custom firmware. Currently, only one axis at a time can be used and all dimensions are in motor steps.
The motors are driven with EasyDrivers.
This video shows an early stage of development, with the first pieces of code for programming vectors implemented.
Please excuse the mess in the background.
Two carriages used as X and Y axis, a servo lifts the pen. The pen carriage is 3D printed, the steel rods come from a third DVD carriage.
The whole thing is driven by an Arduino Duemilanove with custom firmware. Currently, only one axis at a time can be used and all dimensions are in motor steps.
The motors are driven with EasyDrivers.
This video shows an early stage of development, with the first pieces of code for programming vectors implemented.










