Uploaded May 2026 | Updated November 2026, 3 hours ago
A demo of the sort of thing you can do with Reprap firmware Parallel Gcode processing.
The hardware for this project was provided by Duet3d - in order to demonstrate these sort of RRF capabilities.
The configuration is done with OrcaSlicer Gcode overrides and a small Gcode post processor, plus quite a few RRF macro's.
More complicated things - like actual parallel printing are currently also using different tool numbers within OrcaSlicer to tell the printer what things to print in parallel.
A demo of the sort of thing you can do with Reprap firmware Parallel Gcode processing.
The hardware for this project was provided by Duet3d - in order to demonstrate these sort of RRF capabilities.
The configuration is done with OrcaSlicer Gcode overrides and a small Gcode post processor, plus quite a few RRF macro's.
More complicated things - like actual parallel printing are currently also using different tool numbers within OrcaSlicer to tell the printer what things to print in parallel.










