Uploaded July 2016 | Updated November 2026, 3 days ago
Watch the unoxing video here:
youtube.com/watch?v=vNpwbte6oMQ
In this video I will be going through assembly and first power up of the DSO068 DIY KIT oscilloscope. Mind the video is a bit long, but I wanted to cover most of the construction process.
One thing I failed to note there, is that BNC connectors were just a bit too long to easily put the PCB in and out of the case, so there were two options: cut the leads on BNC or move them. I chose the latter and put in hard rubber washers on the BNC on outside of case to move them outwards a bit - you can see those black washers towards the end of video. This mod allowed fur much easier assembly.
Enjoy!
Watch the unoxing video here:
youtube.com/watch?v=vNpwbte6oMQ
In this video I will be going through assembly and first power up of the DSO068 DIY KIT oscilloscope. Mind the video is a bit long, but I wanted to cover most of the construction process.
One thing I failed to note there, is that BNC connectors were just a bit too long to easily put the PCB in and out of the case, so there were two options: cut the leads on BNC or move them. I chose the latter and put in hard rubber washers on the BNC on outside of case to move them outwards a bit - you can see those black washers towards the end of video. This mod allowed fur much easier assembly.
Enjoy!










