Uploaded September 2018 | Updated September 2026, 1 week ago

---

** BUILD VIDEO: youtu.be/LJqPDADi8MM **
Here's a look at my lever-operated plunge router lift. If you want a build video, leave a comment.

SketchUp Models:
3dwarehouse.sketchup.com/by/TheNewbieWoodworker
Viewing SketchUp Models: youtu.be/2e-Bu1UuyY0

All Products featured in my videos: amazon.com/shop/thenewbiewoodworker

Products featured in this video:
Xtreme Xtension Router Collet Extension: amzn.to/2AxfM0H
Rockler Miter Track (36"): bit.ly/2zqbA29
UHMW Plastic - 4" x 24" x 3/8": amzn.to/2DfE80g
Skateboard Bearings: amzn.to/2Cejt7S
Dust Right Small Port Host Kit (Rockler): bit.ly/2Qpa59a
Steel Rod (1/2" x 10"): amzn.to/2xzHMwg
Speed Squares (7" & 12"): amzn.to/2xoYuza

Screws: NOTE: I use 2" screws to attach the lift, but I don't have a link.
Spax Screws (#8, 1 1/4"): amzn.to/2NYXcnP
GRK Screws (#8, 1 1/4"): amzn.to/2QOXQmH

Makita Cordless Hammer Driver-Drill Kit: amzn.to/2uobfrU
Micro-Adjuster (Kreg): amzn.to/2Expyy5
Power Tool Switch - Rockler: amzn.to/2EJyi3m
Push Block - Bench Dog: amzn.to/2Fv6AJ2
Rockler Router Plate: amzn.to/2D4q1q9