DIY rack and pinion dro using esp32 and mlx90393 magnetic encoder @JesseSchoch
DIY rack and pinion dro using esp32 and mlx90393 magnetic encoder  @JesseSchoch
Uploaded August 2021 | Updated November 2026, 1 hour ago
thinking this may work on the lathe, not sure about noise from the motor or if I can run the i2c cable to the esp32 or if I need to keep the esp32 closer to the sensor. rs485 would be better...
DIY rack and pinion dro using esp32 and mlx90393 magnetic encoderCan a $15 motor for cutter grinder spindle work?Diy brushless motor with simple FOC motor controlFun with lasers, chlorine gas, and Dykemgraphene with electrochemical exfoliation testbored?  spin some balls in a bowlespELS part 8 threading in steelconsew csm3000 sewing servo on Jet 836 3/4 bridgeport cloneTroubleshooting TI TPS63802 high current idle current drawp1s Bambu labs sport mode abs...wowstrange mechanism #shortsdiy deckel dbit cutter grinder: u2 arm review: part 4
Jesse Schoch |

DIY rack and pinion dro using esp32 and mlx90393 magnetic encoder

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER