SomethingUnreal | DIY Printer P2: Sliders and calibration @SomethingUnreal | Uploaded 9 years ago | Updated 4 hours ago
Part two in this series of "making of" videos where I make a super-basic printer controlled by an Arduino.
Sorry for being really lazy about uploading this. Also, the upload itself finished a little quicker than I thought it would, so yay, the date at the end is in the future.
Part two in this series of "making of" videos where I make a super-basic printer controlled by an Arduino.
Sorry for being really lazy about uploading this. Also, the upload itself finished a little quicker than I thought it would, so yay, the date at the end is in the future.