Uploaded September 2018 | Updated September 2026, 1 week ago

---

More project information(Code,Schematic,etc):- nematicslab.com/diy-power-supply-using-atx-psu

Website,
NematicsLab.com

Patreon,
patreon.com/NematicsLab

For Sponsorships or Endorsements ONLY!
Business@Nematicslab.com

For project-related questions use Facebook or Twitter @NematicsLab

Electronics Starter kit Tools:
Soldering Iron - banggood.in/custlink/DKGKUAqCKa
Solder wire - banggood.in/custlink/mv3vks2ROf
Helping Hands - banggood.in/custlink/vmvmMAqd0C
Hot Glue - banggood.in/custlink/D3GDMAkWDS

I recently found an ATX Power Supply which offers a quite a decent power at its output. But most importantly it offers +12v, +5V, and +3.3V at its output which is very commonly used in electronics so let's turn this into a Lab Bench Power Supply!

Warning: If you have No idea about electronics then don't try this, AC Mains Voltage is fatal! especially with high voltage capacitor.

---------- Affiliate ----------

Gearbest- bit.ly/2KD54KD
Banggod- bit.ly/2xgJIK5
LCSC - bit.ly/2KD0hJ0

---------- Social Media ----------

Facebook - bit.ly/2FC5lJz
Instagram - bit.ly/2XddQpe
Twitter - bit.ly/2IUhqMm