Uploaded June 2017 | Updated November 2026, 3 hours ago
How to make a patio heater from empty gas/propane tanks.
First of all DO NOT cut into a gas/propane tank unless you know what you are doing! Even though the tank may appear empty there is a risk of explosion and fire. The tanks I used were empty and had their valves removed. They were then filled with water to remove any remaining gas, emptied then refilled again to be sure. The tanks were then left in the open air for a few weeks to vent before being used. YOU HAVE BEEN WARNED!
FYI : It has since been brought to my attention that it may be frowned upon to cut open or modify a gas/propane cylinders in some parts of the world! Be sure to check and follow your local rules and regulations.
Here are some of the many YouTube tutorials I watched before attempting it:
youtu.be/bL1TPvQRZvk
youtu.be/uLEbjlLvLrI
youtu.be/IXQ_umpZajo
youtu.be/wC5yDt0bYkU
All I had to purchase for this project was the 4 inch(100mm) steel tube for the chimney part. It cost €12. The hinge nuts and bolts and the high temperature I already had. I reckon it would have cost about €20 if i had to purchase them.
It is a fairly easy project to do but there is a lot of cutting grinding and sanding. I decided to burn the paint off the cylinder as it was difficult the get it off with the grinder. Thanks for watching !
Music: YouTube audio library.
How to make a patio heater from empty gas/propane tanks.
First of all DO NOT cut into a gas/propane tank unless you know what you are doing! Even though the tank may appear empty there is a risk of explosion and fire. The tanks I used were empty and had their valves removed. They were then filled with water to remove any remaining gas, emptied then refilled again to be sure. The tanks were then left in the open air for a few weeks to vent before being used. YOU HAVE BEEN WARNED!
FYI : It has since been brought to my attention that it may be frowned upon to cut open or modify a gas/propane cylinders in some parts of the world! Be sure to check and follow your local rules and regulations.
Here are some of the many YouTube tutorials I watched before attempting it:
youtu.be/bL1TPvQRZvk
youtu.be/uLEbjlLvLrI
youtu.be/IXQ_umpZajo
youtu.be/wC5yDt0bYkU
All I had to purchase for this project was the 4 inch(100mm) steel tube for the chimney part. It cost €12. The hinge nuts and bolts and the high temperature I already had. I reckon it would have cost about €20 if i had to purchase them.
It is a fairly easy project to do but there is a lot of cutting grinding and sanding. I decided to burn the paint off the cylinder as it was difficult the get it off with the grinder. Thanks for watching !
Music: YouTube audio library.










