DIY Pace Count Beads @ITStactical
DIY Pace Count Beads  @ITStactical
Uploaded February 2020 | Updated November 2026, 15 hours ago
Pace count beads are used to manually track distance when walking. 13 beads are divided into two sections and allow you to track up to 5,000 meters of distance.

To create your own set, you’ll need a 26-inch length of paracord and 13 beads. Trim the ends of the paracord and remove the inner strands. Fuse the ends and tie them in an overhand knot.

Now take one of the inner strands and thread it under the midpoint of the larger piece, meeting the midpoints of both pieces together. Use the inner strand to thread beads onto your larger piece. After threading on 9 beads, measure two finger lengths and tie an overhand knot. Then thread on the remaining 4 beads, measure one finger length and tie a final overhand knot.

Now you’re ready to girth hitch your pace count beads to a pack and begin using them! Every time you walk 100 meters, pull down one bead on the bottom section. When you reach 1,000 meters, reset the bottom beads and pull down a top bead. Later on, we’ll discuss how to create and walk your own pace count line to determine when you’ve traveled 100 meters.

Get the DIY Pace Count Bead Kit! → bit.ly/2VlK1Rd
DIY Pace Count BeadsCan Criminals Copy a Key from a Photo?An Interview with Rifles Only - Gear Tasting Radio 104Snag yours for a limited time for only $99.99!Win Big in Our 10 Days of Giveaways!What’s Your Excuse for Not Having a Tourniquet?Can Your Pockets Help You Survive?The Top 10 Knots You Need to Know: Alpine ButterflyTools for Ascending - Questions Over Coffee 18Designing a New Radio Pouch - Questions Over Coffee 17Where Would Jason Bourne Sit?How to Tie the Girth Hitch for a DIY Knot Board Display
ITS Tactical / Imminent Threat Solutions |

DIY Pace Count Beads

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER