Winston Moy | DIY Motion-Controlled Camera Slider for the Shapeoko 3 Video Shoot @WinstonMakes | Uploaded 9 years ago | Updated 3 minutes ago
Edward Ford invited me to help him film a promo video or two for the Shapeoko 3. To boost my videography street cred and increase production value, I decided to build a camera slider to help me during filming.
See the full trailer(s) at www.shapeoko.com (Coming this afternoon, EST).
Edward Ford invited me to help him film a promo video or two for the Shapeoko 3. To boost my videography street cred and increase production value, I decided to build a camera slider to help me during filming.
See the full trailer(s) at www.shapeoko.com (Coming this afternoon, EST).
![Intro to 5-Axis Machining on the PocketNC v2 - Project #112 [CNC]](https://i.ytimg.com/vi/kdJA0g0E6uQ/hqdefault.jpg "Intro to 5-Axis Machining on the PocketNC v2 - Project #112 [CNC]
After a PocketNC showed up on my doorstep, learning 5-axis machining became my top priority. This is the story of how I went from a 5-axis know-nothing, to a 5-axis amateur.
Let this be a lesson to you all: ALWAYS participate in the Fusion Cam Challenges ;)
To learn more about the PocketNC v2, check out their website: http://www.pocketnc.com/pocket-nc-v2/pocket-nc-v2
Help support content like this: https://www.patreon.com/winstonmoy
Can’t get enough of me? Check out my second channel: https://www.youtube.com/c/WinstonMakesMore
Stalk me on Social Media: @WinstonMakes (insta/twitter)")
![USB-Powered Oak & Acrylic LED Lamp - Project #117 [CNC]](https://i.ytimg.com/vi/lMkf33wdv3Q/hqdefault.jpg "USB-Powered Oak & Acrylic LED Lamp - Project #117 [CNC]
Up-cycling some old acrylic sheeting into an LED lamp by layering it with oak. If I were to do this again, Id frost up the inside surface more to increase diffusion of the LEDs.
LED strip used: https://amzn.to/2DSKLkc
Compression endmill: http://www.harveytool.com/prod/End-Mills-for-Composites/Material-Specific-End-Mills/Browse-Our-Products_248/End-Mills-for-Composites Compression-Cutter_187.aspx
Single Flute Upcut for Plastic: http://www.harveytool.com/prod/End-Mills-for-Plastics/Material-Specific-End-Mills/Browse-Our-Products_253/End-Mills-for-Plastics Square-Upcut Single-Flute_113.aspx_Q_keywords_E_52508
Help support content like this: https://www.patreon.com/winstonmoy
Can’t get enough of me? Check out my second channel: https://www.youtube.com/c/WinstonMakesMore
Stalk me on Social Media: @WinstonMakes (insta/twitter)
*Note: I am a member of the Amazon Affiliate program. By using my links, you are helping to support my content.")
