Uploaded November 2015 | Updated November 2026, 3 hours ago
I'm using proximity sensors for my limit switches. If you are having trouble with your Z axis limit switches not working, try swapping the connector over to the Spindle Enable pins... There are two versions of GRBL, one that uses the old z limit and one that swaps it over. I also hooked up a touch probe and created a macro so it measures the z height of your work accurately by finding the height at medium speed, then again at low speed.
Buy the Proximity Sensors here: ebay.to/1IewFuX
Buy the Arduino & Shield here: ebay.to/1jnHdMr
Buy the Stepper Motors here: ebay.to/1Ngc89u
24V Power Supply here:ebay.to/1Pg55zZ
Follow me on social media
Facebook - facebook.com/gregsgaragekc
Twitter - twitter.com/steelsplinters
Instagram - instagram.com/gregsgaragekc
I'm using proximity sensors for my limit switches. If you are having trouble with your Z axis limit switches not working, try swapping the connector over to the Spindle Enable pins... There are two versions of GRBL, one that uses the old z limit and one that swaps it over. I also hooked up a touch probe and created a macro so it measures the z height of your work accurately by finding the height at medium speed, then again at low speed.
Buy the Proximity Sensors here: ebay.to/1IewFuX
Buy the Arduino & Shield here: ebay.to/1jnHdMr
Buy the Stepper Motors here: ebay.to/1Ngc89u
24V Power Supply here:ebay.to/1Pg55zZ
Follow me on social media
Facebook - facebook.com/gregsgaragekc
Twitter - twitter.com/steelsplinters
Instagram - instagram.com/gregsgaragekc






