jimmydiresta | DiResta Carolina Cutting Board Inlay @jimmydiresta | Uploaded January 2023 | Updated October 2024, 4 days ago.
carolinashoe.com/en/carolina-creates-makers-jimmy-diresta.html

In this video, I try 2 different methods to create an inlay on a cutting board, in the first half of the video I use Total Boat resin poured to the cnc cavity.

In the second half I do a traditional inlay with a piece of walnut into a piece of countertop that I bought at Home Depot. This a tried and proven technique using Vectric V-Carve software check out this video for more information youtube.com/watch?v=l4VMo9DCzO8&t=489s

For me, the learning was about the inlay and not so much about the cutting boards, which is why I went out and bought a few different cutting boards to experiment with.

for support and voiced over version check out
patreon.com/diresta

Thank you
carolinashoe.com
titebond.com
shopbottools.com
vectric.com