Uploaded April 2024 | Updated September 2026, 2 weeks ago

---

UPDATE: I eventually figured out the problem, see this Shmups post from Tim Worthington: shmups.system11.org/viewtopic.php?p=1511761#p1511761

On the last stream, I installed an NESRGB 4 in my OpenTendo NES. However, I didn't fully test the install on that stream. When I did finally test it, I found out that I had skipped some install steps.

This stream, let's go over what I forgot, and diagnose a new issue that could affect your NESRGB 4 install!

Amazon Affiliate Link to USB to TTL programmer: amzn.to/4dfjOsS
Guide to Updating Firmware: https://etim.net.au/nesrgb/NESRGB4_MCU_firmware/

NESRGB Info: https://etim.net.au/nesrgb/
Snap-Fit Multiout Info (non-affiliate link): laserbear.net/products/voultar-nesrgb-qsb-ffc-kits?variant=41892001644756