Cutting a Double Start Acme Thread @StuartdeHaro
Cutting a Double Start Acme Thread  @StuartdeHaro
Uploaded August 2021 | Updated November 2026, 3 hours ago
Here is a job I had to tackle recently at work. It is a replacement valve stem for an outdoor faucet. The material is brass and it needed a double start stub acme thread. The stub acme has a couple of different variations. One has a 60 degree thread angle with a wide flat, and then this style, which I believe is more common. It has the same 29.5 degree angle as a regular acme, but is only about half as deep.


If you like my videos, please consider supporting my channel on Patreon. You'll get access to gag reels and I'll give you a shout out in my videos.

patreon.com/stuartdeharo
Cutting a Double Start Acme ThreadHow to Use Ring and Plug Gages to Check ThreadsQuick Machining Tip #13 - Comparator StandsMaking Graduated Blocks to Help With the Scale TrickBasic Machining Project - Machinists Jack Pt. 7Oiling the Table Nuts On a Bridgeport MillRebuilding an Antique Universal Joint 1911 Willys OverlandThe joys of machining Teflon. So satisfying!Shop Update #2 - The Machines Are In!Fun With MagnetsOil Your Milling Machine, Dont Grease it!How to Use an ACME Thread Gage - Viewer Question Answered
Stuart de Haro |

Cutting a Double Start Acme Thread

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER