Uploaded October 2012 | Updated November 2026, 2 hours ago
Using paperboard or other card stock, construct a rough cube to test the correct section. Use scotch tape or glue to connect the parts but make sure the parts themselves are precisely cut. This rough model is meant to confirm that the section will work. Construct the section leaving the bottom open until the end.
More info about the cube project here:
http://online.sfsu.edu/sketch/cube/
Get some project handouts here:
http://online.sfsu.edu/sketch/cube/pdf/
Using paperboard or other card stock, construct a rough cube to test the correct section. Use scotch tape or glue to connect the parts but make sure the parts themselves are precisely cut. This rough model is meant to confirm that the section will work. Construct the section leaving the bottom open until the end.
More info about the cube project here:
http://online.sfsu.edu/sketch/cube/
Get some project handouts here:
http://online.sfsu.edu/sketch/cube/pdf/










