Uploaded February 2012 | Updated November 2026, 3 hours ago
This video describes a Polycrystalline Mix and Method of assembly and formative stressing that may accentuate current capacity of cell. Stressing Crystal Lattice via MAGNETIC FIELD during formative phase after polarization may be of benefit and worthy of study and experimentation and was first shown by John Bedini in a clip showing crystals growing in solution. My tests using LiClO4 alone indicate Magnetic influence over crystal morphology. Use of LiClO4 as per NextGen1967 on Energetic Forum suggestion has proven to be VERY Interesting to be sure. Credit to him for this material suggestion. It appears as though that material amplifies the rate in which crystals form. The magnetic field affects not only the LiClO4 but perhaps water as well in it lattice distribution during formation. Note I am currently running a cylinder cell with a very similar mix that has been running an oscillator with a 10mm LED for almost FIVE weeks 24/7 with Zero water addition after initial fabrication. All tests shown in this video are of cells that have bench dried for 14hours to 5 days. Note how dry material is in Mortar. MORE STUDY NEEDED TO BE SURE, but seemingly we may be on the right track.
All thoughts welcome
Very Best Regards,
Diveflyfish
This video describes a Polycrystalline Mix and Method of assembly and formative stressing that may accentuate current capacity of cell. Stressing Crystal Lattice via MAGNETIC FIELD during formative phase after polarization may be of benefit and worthy of study and experimentation and was first shown by John Bedini in a clip showing crystals growing in solution. My tests using LiClO4 alone indicate Magnetic influence over crystal morphology. Use of LiClO4 as per NextGen1967 on Energetic Forum suggestion has proven to be VERY Interesting to be sure. Credit to him for this material suggestion. It appears as though that material amplifies the rate in which crystals form. The magnetic field affects not only the LiClO4 but perhaps water as well in it lattice distribution during formation. Note I am currently running a cylinder cell with a very similar mix that has been running an oscillator with a 10mm LED for almost FIVE weeks 24/7 with Zero water addition after initial fabrication. All tests shown in this video are of cells that have bench dried for 14hours to 5 days. Note how dry material is in Mortar. MORE STUDY NEEDED TO BE SURE, but seemingly we may be on the right track.
All thoughts welcome
Very Best Regards,
Diveflyfish










