Uploaded November 2022 | Updated November 2026, 1 day ago
Finally replacing that piece of shit Samsung dryer. It is maybe 5 years old at this point, and it has had to have the rollers in it replaced at least 4 times. Replaced them with ones with and without bearings, it still lasted less than a year. It is really just very poorly made and a terrible design. Dust and lint get everywhere inside of it no matter what you do, and destroys the bushings in the rollers.
After all of those issues, the bearings in the motor started failing (likely due to the same reason). I made a video of the sound that made a while back. The motor at this point is locked up, and I got tired of fixing that cheaply made piece of junk, which is really too new to have any issues. So I found a vintage machine.
As always, the vintage machine is made much better, designed much better, and even though it is over 30 years old and has never been cleaned out or serviced, it still runs flawlessly. I do plan on cleaning it out and lubricating the motor if I can at some point, but everything turns freely and quietly, and it has great air flow, so it is likely fine.
The only issue is that the door is slightly bent on it, so the door switch was not clicking. This was easily fixed however by adding a small rubber bumper on the door where the switch makes contact, at which point it ran perfectly fine. And yes, the door does close far enough to have a good enough seal. It isn’t the space shuttle, it is a 30 year old dryer.
Finally replacing that piece of shit Samsung dryer. It is maybe 5 years old at this point, and it has had to have the rollers in it replaced at least 4 times. Replaced them with ones with and without bearings, it still lasted less than a year. It is really just very poorly made and a terrible design. Dust and lint get everywhere inside of it no matter what you do, and destroys the bushings in the rollers.
After all of those issues, the bearings in the motor started failing (likely due to the same reason). I made a video of the sound that made a while back. The motor at this point is locked up, and I got tired of fixing that cheaply made piece of junk, which is really too new to have any issues. So I found a vintage machine.
As always, the vintage machine is made much better, designed much better, and even though it is over 30 years old and has never been cleaned out or serviced, it still runs flawlessly. I do plan on cleaning it out and lubricating the motor if I can at some point, but everything turns freely and quietly, and it has great air flow, so it is likely fine.
The only issue is that the door is slightly bent on it, so the door switch was not clicking. This was easily fixed however by adding a small rubber bumper on the door where the switch makes contact, at which point it ran perfectly fine. And yes, the door does close far enough to have a good enough seal. It isn’t the space shuttle, it is a 30 year old dryer.










