Could this new control board be enough? - Unboxing SKR3 EZ from BTT @MirageC

Could this new control board be enough? - Unboxing SKR3 EZ from BTT @MirageC

Uploaded May 2022 | Updated September 2026, 2 weeks ago

Unboxing the new BigTreeTech SKR3 EZ and its new format drivers.
Read more about the SKR3 EZ: facebook.com/groups/bigtreetech/permalink/1446662159122747

Could this new control board be enough? - Unboxing SKR3 EZ from BTT

Humidity has more impact than you think on your prints!

X4 Stepper Motors - AWD HevORT with short belt path

Resume 3D print after pause and print surface removal.

500mm/s print speed on HevORT CoreXY MGN Rail 3D Printer - Is it reachable?

HevORT CoreXY Rail MGN - Demo of 3D Printer Printing PLA

Accidental NSFW ?

Finally! a cooling solution that WORKS! #shorts

319mm/s on HevORT - CoreXY MGN rail - Testing Dynamic Acceleration with Duet3D M593 command

Carbon Fiber ABS is sooo Satisfying !

HevORT ZR - Assembly Instruction Z axis Part 1 - Rear Actuator Slider

How fast can the HevORT turn a Benchy?

Could this new control board be enough? - Unboxing SKR3 EZ from BTT