3D-PrintCreator | ▼ Correction, I made a mistake this morning !!! @3dPrintCreator | Uploaded February 2019 | Updated October 2024, 13 hours ago.
▼ Buy me a coffee: support.3d-printcreator.com
▼ Visit my website: 3d-printcreator.com
▼ See the best monthly deals: 3d-printcreator.com/best-monthly-3d-printing-deals
Oops, if you make videos, then sometimes it goes wrong, like this morning when I released the video about designing for 3D printing. In that video I pick up a point that is not wrong in itself because you really have to take into account the way you manufacture something, but I use Simplify3D as a slicer and that software is capable correcting my mistakes without any problem.
YouTube follower unisoldhd told me that I had to make two small changes in my slicer settings and that Simplify3D would just make my print, and that was completely correct. See for yourself what happens.
Thank you unisoldhd for this correction. Super that you have taken the trouble to respond, this makes the world a lot nicer.
With best regards,
Brian 3D-PrintCreator
See all contact details in the info below:
▼ Subscribe to me on YouTube:
subscribe.3d-printcreator.com
▼ Find me on Thingiverse:
thingiverse.3d-printcreator.com
▼ Follow me on Twitter:
twitter.3d-printcreator.com
Keywords for this video:
#designfor3dprinting #cadcam #3dprintcreator
Thanks for watching this video.
▼ Buy me a coffee: support.3d-printcreator.com
▼ Visit my website: 3d-printcreator.com
▼ See the best monthly deals: 3d-printcreator.com/best-monthly-3d-printing-deals
Oops, if you make videos, then sometimes it goes wrong, like this morning when I released the video about designing for 3D printing. In that video I pick up a point that is not wrong in itself because you really have to take into account the way you manufacture something, but I use Simplify3D as a slicer and that software is capable correcting my mistakes without any problem.
YouTube follower unisoldhd told me that I had to make two small changes in my slicer settings and that Simplify3D would just make my print, and that was completely correct. See for yourself what happens.
Thank you unisoldhd for this correction. Super that you have taken the trouble to respond, this makes the world a lot nicer.
With best regards,
Brian 3D-PrintCreator
See all contact details in the info below:
▼ Subscribe to me on YouTube:
subscribe.3d-printcreator.com
▼ Find me on Thingiverse:
thingiverse.3d-printcreator.com
▼ Follow me on Twitter:
twitter.3d-printcreator.com
Keywords for this video:
#designfor3dprinting #cadcam #3dprintcreator
Thanks for watching this video.