Control surface signal corruption with PWM @ardupilot19
Control surface signal corruption with PWM  @ardupilot19
Uploaded June 2024 | Updated November 2026, 12 hours ago
This video shows a quadplane running ArduPilot in MANUAL mode. The forward throttle is raised with no other stick input. The ailerons deflect when the throttle gets to 90% due to corruption of the PWM signal due to the cables being run close to the fwd ESC power wires
The fix was to use 5v signalling on the PWM cables. This can be done either with external level shifter adapters or with the CubeOrange on the 8 main outputs by setting BRD_PWM_VOLT_SEL=1

With thanks to AggieAir from Utah State University for the video
Control surface signal corruption with PWMNathaniel Mailhot   Example of going from simulation to real flight of protoype planeRiku Miyamoto   Kaga MayorAlexander Sandström Remote Aero Search and Rescue operationsStephen Dade: BVLOS With ArduPilot at APDevConf 2025Tilt rotor development Ryan BeallHow to refine Compass Calibration from a flight log4.6 Heli TuningSystems Update by Andrew TridgellBill Geyer : Plane System ID at ApDevConf2025ArduSub  Folklore, Features and FutureHeli Update by Bill Geyer
ArduPilot |

Control surface signal corruption with PWM

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER