Computer Inputs: Pull-Up and Pull-Down Circuits @JustinMillerAutomotive
Computer Inputs: Pull-Up and Pull-Down Circuits @JustinMillerAutomotive
Uploaded May 2020 | Updated September 2026, 2 weeks ago
There are two types of circuits that are used for computer input signals: Pull-up and pull-down circuits. This video explains how these circuits work so that you can know how to test and diagnose sensor circuits.
Computer Inputs: Pull-Up and Pull-Down CircuitsHow much voltage should be present at each point in the circuit?Pre-lubing an engine after a rebuildHow To Use a Multimeter PART 2: MEASURING RESISTANCEHow to test a relay (Hint: you should NOT use an ohmmeter)Adjusting valve lash with bucket liftersChecking valves for leaksChecking Fuses (Using a test light)How to remove a stuck harmonic balancer boltTesting Fuel Injectors with a Lab ScopeMeasuring duty cycle with a multimeterUsing the valve stem seal protector that comes with your new seals
Justin Miller |

Computer Inputs: Pull-Up and Pull-Down Circuits

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER