MakeTech | CO2 Laser Software / K40 Whisperer & Inkscape / Beginner Series Ep. 4 @MakeTechCreate | Uploaded 5 years ago | Updated 2 hours ago
This week, we're going to be looking at setting up CO2 laser software on a 50 watt laser engraver I recently purchased. This laser cutting machine is similar to the popular k40 laser cutter and other Chinese laser engravers, so the setup process should be similar on most of them.

Links to the software we will be using is: bit.ly/3uzqX3x

This video is the fourth in a series of videos I'm doing on co2 laser engravers. Future videos I'll be covering everything from cooling your eBay laser engraver to what software to use on your laser engraver machine.

******Check out other videos in this series******
Chinese CO2 Laser Engraver / 50w Laser Cutter Guide Ep. 1: youtu.be/ssUn6fAODM8
CO2 Laser Engraver Air Assist & Exhaust. Beginner Series Ep. 2 : youtu.be/7lFx9JqlfLk
CO2 Laser Engraver Water Cooling & Laser Chillers. Beginner Series Ep. 3: youtu.be/1wFJv0WbK-c
CO2 Laser Alignment and How to Clean Laser Lens and Mirrors Ep. 5: youtu.be/T9p-1AZKCVg
CO2 Laser Focus / Focusing Laser Lens - Laser Engraver Beginner Series Ep. 6: youtu.be/tPrY3bFdtIw

Other Laser engraver videos -
*********************
How to Make Lasered Engraved Coasters: youtu.be/CPo6jwkSqLg
Laser Cut Leaves / Laser Engraving Leaves: youtu.be/L6GhSj2_phI
*********************
#CO2LaserSoftware #Inkscape #K40Whispere

* Official Website maketechcreate.com
* Follow on Instagram - instagram.com/maketechcreate