Uploaded December 2021 | Updated September 2026, 16 minutes ago

---

In this video I go over out to setup your artwork to line up with the existing branding on tumblers such as hydro flask and yeti. This is done on my OMTech laser with my Mansfield rotary.This is the same process for any device that is compatible with Lightburn such as Aeon, Thunder, OMTech, Rabbit, Boss, and many others.

Lightburn Course
Course.beardedbuildsco.com/store

Support my content by using my affiliate resources and codes below.

I have many of the supplies that I use listed in Amazon affiliate store:
Amazon.com/shop/beardedbuildsco

OMTech Lasers:
omtechlaser.com/LSG

Affiliate code “LASERGUYS”
Coupon code “LASERGUYS5OFF”

OMTech Laser Facebook Group:
facebook.com/groups/1364016877267714/?ref=share

Socials:
Instagram.com/beardedbuildsco

Facebook.com/beardedbuildsco