Uploaded April 2026 | Updated September 2026, 2 weeks ago
Route credit to those who did 3p or to aiderton, idk it happened in multiple dm lol: youtube.com/watch?v=M-WJcyxJHDk
Nothing new since we knew the route was possible just from the 3p route, but this way, you can avoid charging the ppd before getting the panel, and still having a consistent way to do it after.
You need to hold left and look between -2 and -6 degree, on the side of the panel. Eventually you will clip through, and here's the dangerous part. You must not jump, and you must hold s AFTER you are out of the panel hitbox, in order to slow down enough to not go in the crusher. That will give you about 0.1 degree, so repeat this a dozen time. Looking anywhere above -10 degree, will cause you to step up on the panel, having a high chance to reset your ppd (somehow not every time idk why)
After that you charge ppd up to like 5 degree by jumping a few hundred times against the button the way I did, then you let the ppd charge on its own until it doesn't move anymore. Once the ppd cannot charge on its own, do it by jumping again, a few hundred times, until you get your hitbox at about 100 degree, it's not too precise, you just want your hitbox to be past 90.
Then you get the panel into a spd state, which is the only inconsistent part of the map, and so you need to be careful to jump before where the panel is, so your hitbox barely touches it, and puts it into spd. You would see black smokes on all 4 corners of the panel. If you are not careful enough, the panel gets ejected, that's the most consistent way there is currently.
!!IMPORTANT!!
Do NOT keep your vphys inside the conveyor for longer than 1ish second, anywhere near the panel up to the push trigger. This will cause the panel to clip inside the conveyor, and if it is in spd state, to get ejected randomly.
Keep jumping constantly to avoid this issue, and reset your hitbox as soon as you see black smoke.
It doesn't matter the angle the panel get when triggering the spd, it might just make it harder, but if you have reset your hitbox, you have pretty much won, since the only way to lose the LP is to die, but you have a lot of control when boosting from spd.
also don't mind the fact there is a panel at the ending too, i used the save with hacked panels we made back then, but it's not necessary to be there
Route credit to those who did 3p or to aiderton, idk it happened in multiple dm lol: youtube.com/watch?v=M-WJcyxJHDk
Nothing new since we knew the route was possible just from the 3p route, but this way, you can avoid charging the ppd before getting the panel, and still having a consistent way to do it after.
You need to hold left and look between -2 and -6 degree, on the side of the panel. Eventually you will clip through, and here's the dangerous part. You must not jump, and you must hold s AFTER you are out of the panel hitbox, in order to slow down enough to not go in the crusher. That will give you about 0.1 degree, so repeat this a dozen time. Looking anywhere above -10 degree, will cause you to step up on the panel, having a high chance to reset your ppd (somehow not every time idk why)
After that you charge ppd up to like 5 degree by jumping a few hundred times against the button the way I did, then you let the ppd charge on its own until it doesn't move anymore. Once the ppd cannot charge on its own, do it by jumping again, a few hundred times, until you get your hitbox at about 100 degree, it's not too precise, you just want your hitbox to be past 90.
Then you get the panel into a spd state, which is the only inconsistent part of the map, and so you need to be careful to jump before where the panel is, so your hitbox barely touches it, and puts it into spd. You would see black smokes on all 4 corners of the panel. If you are not careful enough, the panel gets ejected, that's the most consistent way there is currently.
!!IMPORTANT!!
Do NOT keep your vphys inside the conveyor for longer than 1ish second, anywhere near the panel up to the push trigger. This will cause the panel to clip inside the conveyor, and if it is in spd state, to get ejected randomly.
Keep jumping constantly to avoid this issue, and reset your hitbox as soon as you see black smoke.
It doesn't matter the angle the panel get when triggering the spd, it might just make it harder, but if you have reset your hitbox, you have pretty much won, since the only way to lose the LP is to die, but you have a lot of control when boosting from spd.
also don't mind the fact there is a panel at the ending too, i used the save with hacked panels we made back then, but it's not necessary to be there
