CBA/ABANA Level-1- The Gate-Latch, Part 3 The Tenoned Staple and associated tooling. @MarkAspery

Uploaded February 2023 | Updated September 2026, 2 weeks ago

Part-3 of a 3-part video series featuring the CBA's and ABANAs gate-latch project.
A lot of this video focuses on the tooling required for the tenoned staple.
The tenoned staple is forged and riveted to the back plate during this video.
If you're clicking through YouTube videos, this one is probably not for you, but if you're making the gate latch, hopefully, I've got you covered.

CBA/ABANA Level-1- The Gate-Latch, Part 3 The Tenoned Staple and associated tooling.

Blacksmithing - Getting Started: Part II - Forging Light Duty Tongs from flat stock - riveting up.

CBA Level III Grille Curriculum - Dave Carroll Grille

Blacksmithing - Getting Started - Forge welding in a gas forge - Part 2 - CBA Level I.

CBA Level III Grille - Coaching Sessions: Methods for Creating the Center Collar

CBA/ABANA level III Grille - Coaching Sessions: Getting started on the grille

CBA/ABANA Level III Grille: Cutting the Base and Capitals, Forging the Tenons, Assembly of the Frame

Blacksmithing - Getting started - Forge welding in a gas forge. CBA Level I.

Blacksmithing - Getting started: Forging the shaft for the Blacksmiths Calipers - Calipers Part I.