Can’t Refit The Metering Needle, Spring and Lever? Try This @TheRepairSpecialist
Can’t Refit The Metering Needle, Spring and Lever? Try This  @TheRepairSpecialist
Uploaded August 2026 | Updated November 2026, 13 hours ago
Easily Rebuild your two-Stroke Chainsaw Carburetors Metering System with this technique.

I show you how to re fit the Metering Needle, Metering Spring, Metering Lever and Metering Pin, and then how to reset the metering lever height.

I hope you benefit from it.

Craig (The Repair Specialist)
Can’t Refit The Metering Needle, Spring and Lever? Try ThisCAREFUL - Lawnmower Excessive Vibration does this to the Ignition Coil!3 Decades fixing Chainsaw Bog When Throttle Up  - I Always do this!Why not to run a Chainsaw too LeanHow the Hidden LOW Screw Actually Tunes the Carburetor (by Craig Kirkman)This is what 5W30 Multigrade Engine Oil Actually MeansWhy You Cant Adjust Some Chainsaw Carburetors....Manufacturers Make it Difficult!Simple Test for ON Switch Shorting out - Lawnmower (by Craig Kirkman)I bought the Cheapest Pot & Piston from Amazon and Run my SawDecades Repairing Chainsaws. I now do this.....How Does a Multimeter REALLY Turn 9V Into a Digital Reading? ⚡ #ShortsCarburetor Adjuster tools kit (2 Stroke Chainsaw Carburetor)
TheRepairSpecialist |

Can’t Refit The Metering Needle, Spring and Lever? Try This

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER