Uploaded December 2025 | Updated November 2026, 3 hours ago
#siserjuliet#X Tool S1#SVGs#Projects#Multicrafting
Inspiration for your inner crafter
Written instructions
The calibration does not need to be printed, use the laser to score some paper.
Set up a test design in Studio as usual, distance test and set it all to score only.
Move the paper to another position.
Lower the laser head FULLY and position it over the top left corner.
Snap design to new location and cut it again.
Look closely to see if the design is cutting where it should. If it is, great. You don't need to do anything else.
If not, measure the amount it is off in both horizontal and vertical directions.
Adjust the DESIGN coordinates as needed, then repeat the test. (Increasing the X axis number moves the design to the right, increasing the Y axis number moves the design down.) Note any changes you needed to make.
For projects you wish to print and cut, make sure to add a line border to the design before printing, regardless of if you are exporting a file from Studio to print, or using other design software. Make sure that you know what size that border prints at, and when importing into Studio, check that the size is the same.
Lower the laser head to use the crosshairs, snap to laser, apply any changes you needed to make. (Mine needs x-1 and Y+1).
Createinspain FaceBook facebook.com/groups/createinspain
My second YouTube channel - Siser Juliet Beginners To Pro
Laser cutting Channel - youtube.com/@LaserLove-1
Face Book facebook.com/groups/SiserJulietBeginnersToPro
facebook.com/groups/createinspain
Buy me a coffee
ko-fi.com/createinspain
#siserjuliet#X Tool S1#SVGs#Projects#Multicrafting
Inspiration for your inner crafter
Written instructions
The calibration does not need to be printed, use the laser to score some paper.
Set up a test design in Studio as usual, distance test and set it all to score only.
Move the paper to another position.
Lower the laser head FULLY and position it over the top left corner.
Snap design to new location and cut it again.
Look closely to see if the design is cutting where it should. If it is, great. You don't need to do anything else.
If not, measure the amount it is off in both horizontal and vertical directions.
Adjust the DESIGN coordinates as needed, then repeat the test. (Increasing the X axis number moves the design to the right, increasing the Y axis number moves the design down.) Note any changes you needed to make.
For projects you wish to print and cut, make sure to add a line border to the design before printing, regardless of if you are exporting a file from Studio to print, or using other design software. Make sure that you know what size that border prints at, and when importing into Studio, check that the size is the same.
Lower the laser head to use the crosshairs, snap to laser, apply any changes you needed to make. (Mine needs x-1 and Y+1).
Createinspain FaceBook facebook.com/groups/createinspain
My second YouTube channel - Siser Juliet Beginners To Pro
Laser cutting Channel - youtube.com/@LaserLove-1
Face Book facebook.com/groups/SiserJulietBeginnersToPro
facebook.com/groups/createinspain
Buy me a coffee
ko-fi.com/createinspain










