Cable Measurement Tutorial @FesZElectronics
Cable Measurement Tutorial  @FesZElectronics
Uploaded June 2026 | Updated September 2026, 1 week ago
#280 In this short video I look at one of the ways in which the velocity factor and the characteristic impedance of a cable can be measured using a VNA and a tape measure.

Related content:
Cable Verification Tests: youtu.be/LmL1Qj-hGvk
Cable Measurement tutorial: youtu.be/WdVtP6KaoZE

Used software:
coppermountaintech.com/demo-the-software

Special Thanks to all my supporters on Patreon!

If you liked this video be sure to check out my other videos and you can also subscribe to be up to date with all the new ones!
If you want to support the creation of more and better videos please consider checking out: patreon.com/feszelectronics
Cable Measurement TutorialElectronic Switches - SMPS and snubbers (2/2)How to setup your VNA measurementsLTspice tutorial - Re-using standard component symbolsAbout CIRCUIT LOOPS in amplifiers4 year anniversary special3-Way RF Signal SplittersAbout Current Probes and TransformersCommon Collector Amplifier - Theory and Basics (1/2)DIY BenchSupply [1/2]SMPS Noise Analysis - A Practical TestcaseIntro to Filters
FesZ Electronics |

Cable Measurement Tutorial

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER