Building the Velleman K8200 3D printer - Part 3: Printing and Calibration @SwitchAndLever
Building the Velleman K8200 3D printer - Part 3: Printing and Calibration  @SwitchAndLever
Uploaded October 2014 | Updated November 2026, 3 days ago
The final installment of the Velleman K8200 build. We take a look at some initial prints in ABS, some grand failures and quite a bit of tweaking in how to get it to print properly.

Be sure not to miss the previous two parts of this build series: youtube.com/playlist?list=PL8SXf2Eh08yrnlc55aeeYs_5mkVYcHSYh

To download the 3d model mentioned in the vide, go to the following link: switchandlever.com/plans/royalCrown.zip

Music:
Josh Woodward - California Lullaby
Josh Woodward - Swansong
Building the Velleman K8200 3D printer - Part 3: Printing and CalibrationMake a Game Cartridge Hard DriveMaking a Simple Marking KnifeA Weekend in the Forge (Blacksmithing Course)Top 10 Frequently Asked Questions1 min Project: Halloween CostumeThe New Arduino Giga R1 WiFi (Part 1) #arduino #gigar1wifiGoing to the Turkish Antiques BazaarArduino Egg Carton GamepadThe RadioShack Executive Decision MakerRestoring Vintage Toggle SwitchesMake a Knife Handle From Cat Hair
Switch & Lever |

Building the Velleman K8200 3D printer - Part 3: Printing and Calibration

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER