Building Engines the Right Way: Connecting Rod Assembly πŸ”§ @crateengines
Building Engines the Right Way: Connecting Rod Assembly πŸ”§  @crateengines
Uploaded June 2026 | Updated November 2026, 2 hours ago
Getting ready to put the rods on these forged pistons! I’ve got a couple seated already, but I wanted to show you the right way to handle this using a connecting rod oven.

The Assembly Process

Mark Your Parts: Always mark the connecting rod first so you know exactly which way is front before you apply any heat.

Apply the Heat: We place the rod in the oven for about 15 seconds to get the temperature just right.

Assemble: Once it's properly heated, the pin will slide right into the piston. Let it cool, and it's perfectly set.

The Golden Rule of Rod Ovens
"The whole idea is to put the proper amount of heat without cherrying the connecting rod."

You can't over-cherry them! Some guys out there are absolutely nuts with how they do things, cooking the metal until it glows. That's a great way to compromise the structural integrity of a good connecting rod. Heat it just enough for a clean slide-in fit, and you're good to go.

Proformance Unlimited
Melbourne, FL
321-430-2465
ProformanceUnlimited.com

#EngineBuilding #MechanicLife #AutoShop #ConnectingRods #Pistons #GoodsonTools #TechTips
Building Engines the Right Way: Connecting Rod Assembly πŸ”§πŸ¦– Unleashing the Godzilla! 7.3L V8 Dyno Pull πŸ’₯88 Ford MustangLS3 427CI Stroker Performance Engine Dyno TestWe Built an 849HP Whipple Supercharged LS… For an AIRBOAT?!524HP & 543 TQ! 408CI Small Block Ford Dyno Test & Tune 🏁347 Engine Dyno Test! (Built for a 66 Mustang)LQ9 408CI Airboat EngineInnoV8 Stack Injected 7.3L Ford Godzilla Performance Engine Dyno Test704 horsepower. 639 lbft. One purpose-built LS.Continuation of our 360 Magnum buildLS 427CI Whipple Supercharged Performance Crate Engine
Proformance Unlimited |

Building Engines the Right Way: Connecting Rod Assembly πŸ”§

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER