This Old Tony | Build Your Own CNC! (Part 1) - Hardware @ThisOldTony | Uploaded 5 years ago | Updated 6 hours ago
CNC Etch-A-Sketch! Probably as good a project as any to get a handle on the basics. Very basics.
Tentatively, the big picture is this:
Part 1: CNC hardware / electronics / wiring
Part 2: Software, setup and calibration youtu.be/eLdlV3-JaH8
Part 3: Machine Design
--
Music:
"Sally Goodin" & "Reuben's Train" - Nat Keefe with The Bow Ties
CNC Etch-A-Sketch! Probably as good a project as any to get a handle on the basics. Very basics.
Tentatively, the big picture is this:
Part 1: CNC hardware / electronics / wiring
Part 2: Software, setup and calibration youtu.be/eLdlV3-JaH8
Part 3: Machine Design
--
Music:
"Sally Goodin" & "Reuben's Train" - Nat Keefe with The Bow Ties