Blacksmithing - Getting started: The handle to the slide of the Trammel Hook, Trammel Hook  part III @MarkAspery
Blacksmithing - Getting started: The handle to the slide of the Trammel Hook, Trammel Hook  part III  @MarkAspery
Uploaded May 2020 | Updated November 2026, 4 days ago
#helpingannalisa, #Bringstyvirtual, This video focuses on the handle to the slide of the Trammel Hook. The handle comprises of a tenon, a forged ball and a short taper between the two, a tight forging. Part IV will look at fitting the handle and finishing the slide.
The Trammel Hook series is part of a community effort to take blacksmith education online during the COVID-19 pandemic.
Blacksmithing - Getting started: The handle to the slide of the Trammel Hook, Trammel Hook  part IIICBA/ABANA Level III Grille - Coaching Sessions: Area Calculations for the upset corners to weld areaABANA Curriculum Grille #5. Forge weldingCBA Grille #6 By Dennis Dusek & Brett Moten - center collar tooling. CBA Level III GrilleWater leaf development. CBA Level III Grille.Blacksmithing - Trace Hook, Old-School project #1Forged Full-Bodied HorseCBA/ABANA National Curriculum Level III Grille - Coaching Session: The Beveled ScrollUpset corners for the CBA Level III Grille.High Relief Chasing with Heather McLartyBlacksmithing - Wizard Headed Bottle OpenerCBA/ABANA National Curriculum Level III - Coaching Sessions: The Central Collar Material Swage
Mark Aspery |

Blacksmithing - Getting started: The handle to the slide of the Trammel Hook, Trammel Hook part III

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER