Uploaded October 2023 | Updated September 2026, 1 week ago
Hey folks, today's vid is all about fixing up the BeagleCamera V2 and getting that time-lapse photography set up in Beagleprint - big shoutout to "@jobalcazar9529" for pointing this out!
So first off, I snapped the Camera onto the printer’s X-axis using a C-clip and bracket, popped open the Beagleprint app, found the Camera device, and hit the settings in the top right corner. Found the time-lapse settings in there, and you can pick your mode, like Clean Time-lapse, and tweak other stuff like nozzle movement and retraction settings down below.
And that's the scoop! If anything's got you scratching your head, just drop me a comment and we'll figure it out together. 👍
Hey folks, today's vid is all about fixing up the BeagleCamera V2 and getting that time-lapse photography set up in Beagleprint - big shoutout to "@jobalcazar9529" for pointing this out!
So first off, I snapped the Camera onto the printer’s X-axis using a C-clip and bracket, popped open the Beagleprint app, found the Camera device, and hit the settings in the top right corner. Found the time-lapse settings in there, and you can pick your mode, like Clean Time-lapse, and tweak other stuff like nozzle movement and retraction settings down below.
And that's the scoop! If anything's got you scratching your head, just drop me a comment and we'll figure it out together. 👍
