Basic & Intermediate Outdoor Climbing: 8. Top Rope Anchor - The -Sliding X- | Climbing Tech Tips @ClimbingTechTips
Basic & Intermediate Outdoor Climbing: 8. Top Rope Anchor - The -Sliding X- | Climbing Tech Tips  @ClimbingTechTips
Uploaded February 2018 | Updated November 2026, 3 hours ago
Subscribe to our channel for the latest training videos, climbing tutorials and more! Unlike gym climbing, outdoor climbing typically requires an anchor to be created at the top of the route. There are several anchor systems to choose from. In this video, we review the “Sliding X.” This is an anchor which has gone in and out of style through the years, and has some pitfalls. It is not our most recommended anchor style, but we discuss it here so that you are familiar with if, how, and when to use it.

The main benefit of the Sliding X is that it can automatically adjust the equalization point; therefore, it can be a good choice for a wandering climb, where the climber will traverse while climbing to the anchor.

2 - Pre-existing bolts and hangers
2 - Double-length slings
2 - Non-locking carabiners
AND
1 - Locking carabiner -and- 1 non-locking carabiner
OR
2 - non locking carabiners
OR
2 - locking carabiners for the Master Point

Step 1 - Clip the 2 non-locking carabiners into the bolted anchor points (one carabiner for each bolt hanger).

Step 2 - Clip two double length slings (for redundancy) into each carabiner, and pull in the direction of the climber.

Step 3 - Holding each “half” of the double length sling in one hand, which means you’ll have two strands in each hand, flip one to create a loop. This marks the X of the Sliding X.

Step 4 - Clip all four strands with two opposite and opposed carabiners. The carabiners should slide smoothly from side to side as the slings adjust the equalization point.

NOTE: At no point should the Master Point (which is less defined in this anchor, but is where the opposite and opposed carabiners rest) drop down and shock load either piece of the anchor. This is possible with the Sliding X if one of the bolts were to fail (and violates SRENE, see video). For this reason, we use two double length slings so we are very confident in the strength of the slings, and two unquestionably solid bolts.


We hope you found this video helpful.

Please remember, climbing is inherently dangerous. Climb at your own risk. Visit ClimbingTechTips.com for related comments, additional videos, and community feedback!
Basic & Intermediate Outdoor Climbing: 8. Top Rope Anchor - The -Sliding X- | Climbing Tech TipsBouldering: 9. Taping to Prevent Injury | Climbing Tech TipsAid Climbing & Big Walls: 16. Aid Climb Like You Lead - Free Climb | Climbing Tech TipsGym Lead Climbing: 9. Lead Falling | Climbing Tech TipsIce Climbing: 3. Alternate vs. Horizontal Placements | Climbing Tech TipsYoga & Stretching for Climbing: 11. Yoga & Stretching for Dynos | Climbing Tech TipsAlpine & Mountaineering: 4. Snow Travel - Chopping Steps | Climbing Tech TipsIce Climbing: 6. Mono-Point Crampons vs. Dual-Point Crampons | Climbing Tech TipsTraditional Climbing: 3. Finger Locks vs. Laybacking Cracks | Climbing Tech TipsBouldering: 8. The Importance of Sanding your Fingers | ClimbingTechTipsAlpine & Mountaineering: 25. Ascending Fixed Lines | Climbing Tech TipsIce Climbing: 5. Wearing & Adjusting Crampons | Climbing Tech Tips
Climbing Tech Tips |

Basic & Intermediate Outdoor Climbing: 8. Top Rope Anchor - The -Sliding X- | Climbing Tech Tips

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER