Uploaded January 2025 | Updated November 2026, 1 hour ago
How would you go about cutting material off the prongs?
Link to Reddit post:
reddit.com/r/Fusion360/comments/1i1258f/projecting_onto_curves_or_just_notching
Link to starting file:
a360.co/40zRJXM
If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true
Disclosure: Autodesk has kindly sponsored the full version of Autodesk Fusion that is used to produce the videos on this channel. That being said, Autodesk has no editorial control over the content on this channel. I am still an independent creator with the aim of creating videos that help viewers in using Autodesk Fusion.
#autodeskad
#fusion360school
How would you go about cutting material off the prongs?
Link to Reddit post:
reddit.com/r/Fusion360/comments/1i1258f/projecting_onto_curves_or_just_notching
Link to starting file:
a360.co/40zRJXM
If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true
Disclosure: Autodesk has kindly sponsored the full version of Autodesk Fusion that is used to produce the videos on this channel. That being said, Autodesk has no editorial control over the content on this channel. I am still an independent creator with the aim of creating videos that help viewers in using Autodesk Fusion.
#autodeskad
#fusion360school










