Uploaded April 2026 | Updated September 2026, 2 weeks ago
I thought it would be good to show the file for the NASA Artemis carving in Fusion where I created it. I started by importing the moon’s surface from NASA scan data that I processed in QGIS software. Then I imported the Artemis logo and traced the outline of the letters and graphics. The time consuming part was getting the section to be less than the thickness of the wood I was going to carve it out of, which was 1.75" thick.
@adskFusion @NASA @NASAKennedy #fusion #nasa #artemis #nasaartemis #NASAKennedy
I thought it would be good to show the file for the NASA Artemis carving in Fusion where I created it. I started by importing the moon’s surface from NASA scan data that I processed in QGIS software. Then I imported the Artemis logo and traced the outline of the letters and graphics. The time consuming part was getting the section to be less than the thickness of the wood I was going to carve it out of, which was 1.75" thick.
@adskFusion @NASA @NASAKennedy #fusion #nasa #artemis #nasaartemis #NASAKennedy
