Uploaded January 2017 | Updated November 2026, 4 days ago
Roger explains how to reverse-engineer the ATTEN AT80D solder-station, how the analog circuitry works and how finally to fix the problem with the falsely displayed temperatures.
Support Roger on Patreon: patreon.com/kainkalabs
The ATTEN AT80D soldering station has a severe problem with the displayed temperature vs. the measured temperature at the solder-tip.
Demonstrated in this video: youtu.be/phDOs18MbRs
This is because the temperature is measured at the heater-element and not at (or at least near) the solder-tip.
So there is a big temeprature-differential due to the thermal resistance between the heater-element and the solder-tip.
It could have been easily fixed in software or with the change of a single resistor in the hardware by ATTEN.
Furthermore the contact-area between the heater-element and the solder-tip is very small. Thus the thermal-resistance is big and the control-loop for the temperature is not very stable with a big time-lag from switching the heater-element on until the heat has finally reached the solder tip.
Download-Link for Schematics & Pictures:
https://1drv.ms/u/s!AmW9-q-1GZM1g_YzAfAC5cSTP58FAg
Roger explains how to reverse-engineer the ATTEN AT80D solder-station, how the analog circuitry works and how finally to fix the problem with the falsely displayed temperatures.
Support Roger on Patreon: patreon.com/kainkalabs
The ATTEN AT80D soldering station has a severe problem with the displayed temperature vs. the measured temperature at the solder-tip.
Demonstrated in this video: youtu.be/phDOs18MbRs
This is because the temperature is measured at the heater-element and not at (or at least near) the solder-tip.
So there is a big temeprature-differential due to the thermal resistance between the heater-element and the solder-tip.
It could have been easily fixed in software or with the change of a single resistor in the hardware by ATTEN.
Furthermore the contact-area between the heater-element and the solder-tip is very small. Thus the thermal-resistance is big and the control-loop for the temperature is not very stable with a big time-lag from switching the heater-element on until the heat has finally reached the solder tip.
Download-Link for Schematics & Pictures:
https://1drv.ms/u/s!AmW9-q-1GZM1g_YzAfAC5cSTP58FAg










