Uploaded February 2019 | Updated November 2026, 11 hours ago
Component placement and first attempt at reflow. Flux bubbled heavily and sent the BGAs flying and knocking into everything else. Additionally, the increased time on the reflow profile seemed to melt some of the plastics pretty badly. Next up is to clean up the shorts near the FTDI and bring that up, depop the damaged BGAs, and try to bring up the nRF (and replace the damaged BGAs).
Component placement and first attempt at reflow. Flux bubbled heavily and sent the BGAs flying and knocking into everything else. Additionally, the increased time on the reflow profile seemed to melt some of the plastics pretty badly. Next up is to clean up the shorts near the FTDI and bring that up, depop the damaged BGAs, and try to bring up the nRF (and replace the damaged BGAs).










