Uploaded February 2024 | Updated September 2026, 3 hours ago
Follow along to assemble the sled of the Maslow4. Written instructions can be found on our website here:maslowcnc.com/assembling-the-sled
In addition to the parts in the Maslow4 kit, you may want to have some masking tape, a hammer and scissors nearby. None of these are mandatory, but you will see them used in this video.
This video is meant to show assembly at a reasonable pace. If you work faster than the video, here are some time stamps so that you can skip ahead.
Introduction 0:00
Attaching the stepper motors 3:46
Attaching the dust cover 7:29
Taping on the dust cover 11:29
Bar's trick for adding screws for the dust cover 14:29
Anna's recommendation for the dust cover 16:19
Adding the linear rods 21:27
Attaching the linear rock clamps 22:13
Follow along to assemble the sled of the Maslow4. Written instructions can be found on our website here:maslowcnc.com/assembling-the-sled
In addition to the parts in the Maslow4 kit, you may want to have some masking tape, a hammer and scissors nearby. None of these are mandatory, but you will see them used in this video.
This video is meant to show assembly at a reasonable pace. If you work faster than the video, here are some time stamps so that you can skip ahead.
Introduction 0:00
Attaching the stepper motors 3:46
Attaching the dust cover 7:29
Taping on the dust cover 11:29
Bar's trick for adding screws for the dust cover 14:29
Anna's recommendation for the dust cover 16:19
Adding the linear rods 21:27
Attaching the linear rock clamps 22:13
