Uploaded October 2016 | Updated September 2026, 2 weeks ago

---

Control the position of the Servo motor with the Arduino and the potentiometer.

Required Hardware:
Arduino Board amzn.to/2LZr6t4
Servo Motor amzn.to/3avwe1N
10k ohm Potentiometer amzn.to/3dlgYq1
Jumper Wires amzn.to/3doetmT
Mini Breadboard amzn.to/2M15Wea

Recommended Items:
Use Your Muscles in Project - amzn.to/3wdL45C
37 Sensor & Module Packages - amzn.to/3m66WeQ
Try this Robot Arm - amzn.to/3fq8DCl
Best Resin 3D Printer - amzn.to/39tY8KB
Arduino Compatible Kits - bit.ly/2J2AFF7
Banggood Spring Sale - bit.ly/3slMbOn

Servo motors have three wires: power, ground, and signal. The power wire is typically red, and should be connected to the 5V pin on the Arduino or Genuino board. The ground wire is typically black or brown and should be connected to a ground pin on the board. The signal pin is typically yellow or orange and should be connected to pin 9 on the board.

The potentiometer should be wired so that its two outer pins are connected to power (+5V) and ground, and its middle pin is connected to analog input 0 on the board.

I recommend! You not connect directly the servo motor to the Arduino. I suggest you use external power to the servo. SG90 Mini Servo motors can be used.

Get Source Code: create.arduino.cc/editor/mertarduinotech/d3dde748-e44e-44dd-a09b-25dadc34a508/preview

Social Media:
instagram.com/mertarduino
facebook.com/mertarduino