Arduino GIGA Display Shield @Dronebotworkshop
Arduino GIGA Display Shield  @Dronebotworkshop
Uploaded November 2023 | Updated November 2026, 20 minutes ago
The Arduino Giga Display Shield is a touchscreen display with an IMU, microphone, RGB LED, and camera connector.

Article with code: dronebotworkshop.com/giga-display
More articles and tutorials: dronebotworkshop.com
Join the conversation on the forum: forum.dronebotworkshop.com
Subscribe to the newsletter and stay in touch: dronebotworkshop.com/subscribe

We have already looked at the Arduino Giga; it’s an advanced microcontroller that brings the horsepower of the Portenta series to a board with an Arduino Mega format.

Today, we will look at an exciting accessory for the Giga, the Arduino Giga Display Shield. This is a full-featured 800x480 TFT display with a capacitive touch screen. It also has an onboard IMU so you can read the display orientation, a MEMS microphone, and an RGB LED. There is also an extension of the Giga’s existing camera connector on the front of the display.

This device is called a “shield,” but it actually mounts on the underside of the GIGA board, using the display and camera connectors. This arrangement makes for a very straightforward hardware setup, and you can still use conventional shields on the Arduino when the display is mounted.

In this video, I will walk you through all the features of the Arduino Giga Display Shield. Here is the Table of Contents for today's presentation:

00:00 - Introduction
01:25 - Arduino Giga Display Shield
05:08 - Getting Started
06:47 - RGB LED Coding
08:26 - IMU Coding
10:30 - Microphone Coding
14:54 - ArduinoGraphics Library
16:32 - ArduinoGraphics Library Demo
19:13 - Arduino Logo Demo
21:42 - Displaying Your Own Images
25:04 - GFX Library
26:20 - GFX Library Demo
29:33 - LVGL Library & Framework
32:10 - LVGL Demo Code
36:42 - LVGL with IMU and Image
39:49 - Touch Screen Intro
40:58 - Touch Screen Polling Demo
43:44 - Touch Screen Interrupt Demo
46:10 - Camera
48:22 - Camera Demo
53:02 - Conclusion

I think that this display would make an ideal “master control panel,” perhaps for an Arduino IoT Cloud project. You can expect to see it again in another video!
Arduino GIGA Display ShieldBuild an Electronic Level with MPU-6050 and ArduinoTMP117 Precision Temperature Sensor - Build a WiFi ThermometerBuild an ESP32-CAM Developers Module with Power SupplyBreadboarding & Prototyping for Electronics, Arduino & Raspberry PiLoRa - Long-Range Radio for IoT | Arduino, ESP32, RPI Pico74HC595 & 74HC165 Shift Registers with ArduinoHC-SR501 PIR Motion Detector - With Arduino & Raspberry PiDB1 Episode 16 - Going Forward & I/O DocumentationRaspberry Pi Pico - Control the (I/O) WorldArduino Touchscreen Display - Using a Resistive TouchscreenOp-Amps  - Using Operational Amplifiers
DroneBot Workshop |

Arduino GIGA Display Shield

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER