Arcing Sand With My Homemade High Voltage Flyback Transformer, Current, and Power Tests @makerj101
Arcing Sand With My Homemade High Voltage Flyback Transformer, Current, and Power Tests  @makerj101
Uploaded April 2014 | Updated November 2026, 2 days ago
Making some glass with high voltage! I'm definitely putting over 800 watts into the transformer. The current going into the variac is 10-11 amps at 120 volts AC. Output from variac is about 40 volts and drops to about 30 volts DC when arcing. Current is about 30-35 amps. So about 900 watts going into the ZVS. The current coming out of the transformer is about 0.6 amp. So dividing 900 watts by 0.6 amp = 1500 volts. So not a very high voltage at all. It's probably more voltage then that when I am not arcing with it. The arc strikes when I get about 1/2 inch away so I think that is more than 1.5kv.
Hope you enjoyed!
Thank you for watching!
Arcing Sand With My Homemade High Voltage Flyback Transformer, Current, and Power TestsHydrostatic Testing My Homemade Tomato Sauce Can Boiler to 60PSI500 Subscriber Thank You! CRT Smash, Close Up Tesla Coil Plasma, Christmas Lights PopFirst Run of My New DIY Stirling Engine #5Internal Combustion, Steam, and Stirling engines running at My Maker Faire Pittsburgh Booth!New Camcorder Unboxing JVC Everio GZ-E306Garden Update 2014-8-29Induction Heating With ZVS Driver - Flat Induction Coil Boiling Water and Litz Wire CoilsSoldering a New Pressure Relief Valve On My Boiler and How to SolderFan Vortex Boiler Burner Problem SolutionHuge Ice Igloo - They Last So Much Longer Than a Snow Cave And Are Easier To Dig OutAttempting Glassblowing and Making a Helium Discharge Lamp
Makerj101 |

Arcing Sand With My Homemade High Voltage Flyback Transformer, Current, and Power Tests

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER