Uploaded May 2019 | Updated September 2026, 2 weeks ago
I'm back! Sort of... Sorry that this vid is super choppy. I had to record in a few different session and then slice and dice them together, so it is a bit of a mess. This vis is a combination of Q&A, updates, news, and philosophy. Feel free to skip around using the index below:
00:05 updated and plans
5:27 - beginning of Q&A segment
8:10 - why no smoothie board review & 24v vs 12v
13:39 - Dutch tangent
16:22 - VFA with trinamics?
18:41 - integrated leads crew
19:15 - 2 cycle oil?
20:13 - design philosophy, axial loads on steppers, etc
29:52 - complaints about community interface
30:54 - running leadscrew against motor shaft end with flexible coupler
32:18 - lubing lmuu bearings
32:56 - end supported linear railway
35:35 - mks mini lcd
36:58 - tmc5161?
I'm back! Sort of... Sorry that this vid is super choppy. I had to record in a few different session and then slice and dice them together, so it is a bit of a mess. This vis is a combination of Q&A, updates, news, and philosophy. Feel free to skip around using the index below:
00:05 updated and plans
5:27 - beginning of Q&A segment
8:10 - why no smoothie board review & 24v vs 12v
13:39 - Dutch tangent
16:22 - VFA with trinamics?
18:41 - integrated leads crew
19:15 - 2 cycle oil?
20:13 - design philosophy, axial loads on steppers, etc
29:52 - complaints about community interface
30:54 - running leadscrew against motor shaft end with flexible coupler
32:18 - lubing lmuu bearings
32:56 - end supported linear railway
35:35 - mks mini lcd
36:58 - tmc5161?
