Uploaded January 2021 | Updated September 2026, 2 weeks ago
This is to show how you upgrade the z axis screws on the Anycubic Mega Pro. One point to mention and this has been brought to my attention by a viewer, after fitting the nuts his nozzle was hitting the bed. Possible cause, when fitting the anti backlash nuts do not move the z axis adjustment screws, they are situated one on either side of the anti backlash nuts they level the z axis when touching the micro switches on the base at each side. To be safe just adjust the build plate down then re-level when finished.
This is to show how you upgrade the z axis screws on the Anycubic Mega Pro. One point to mention and this has been brought to my attention by a viewer, after fitting the nuts his nozzle was hitting the bed. Possible cause, when fitting the anti backlash nuts do not move the z axis adjustment screws, they are situated one on either side of the anti backlash nuts they level the z axis when touching the micro switches on the base at each side. To be safe just adjust the build plate down then re-level when finished.
