Uploaded November 2018 | Updated September 2026, 15 minutes ago
where the first initial nozzle contact, once it makes a complete circle, there is a small jolt or bump, there is nothing on the bed causing it and it is not hitting the previous fill, I can remove filament and it will jolt the same location where the nozzle first makes contact near in air. Doesn't matter if is a circle square, different starting point, it always joint at the first initial contact.
where the first initial nozzle contact, once it makes a complete circle, there is a small jolt or bump, there is nothing on the bed causing it and it is not hitting the previous fill, I can remove filament and it will jolt the same location where the nozzle first makes contact near in air. Doesn't matter if is a circle square, different starting point, it always joint at the first initial contact.
