Uploaded April 2022 | Updated September 2026, 2 weeks ago
I picked up a few three jaw chucks and cleaned them up. There are enough backing plates out there already, and I needed a different approach for this one anyway, so I made a threaded spindle adapter to mount a Hardinge Chuck on my Logan lathe. I also needed a chuck key, so I made one out of a scrap drill bit.
If you like what I'm doing here and find some value in it, consider supporting my work on Patreon: patreon.com/Jeremymakesthings
I promise I'll still mostly make stuff out of rusty junk and not just buy shiny things with your money.
I picked up a few three jaw chucks and cleaned them up. There are enough backing plates out there already, and I needed a different approach for this one anyway, so I made a threaded spindle adapter to mount a Hardinge Chuck on my Logan lathe. I also needed a chuck key, so I made one out of a scrap drill bit.
If you like what I'm doing here and find some value in it, consider supporting my work on Patreon: patreon.com/Jeremymakesthings
I promise I'll still mostly make stuff out of rusty junk and not just buy shiny things with your money.
